How To Repair Sliding Door
How to repair a sliding door tuning up a balky door for sliding glass door repair.
How to repair sliding door. Cut the paint or varnish line on the room side of the. Unscrew the rollers and remove them. Clean out the tracks. Lift the door straight up at the same time push in at the bottom of the door and let it back down on the track.
You can find replacement patio sliding glass door hardware here. Basic rules to get your door rolling smoothly. If the problem is just a loose roller tighten or replace the loose screws that hold it in place. To replace torn or cracked weatherstripping where the sliding and fixed panels overlap loosen its staples with a flathead screwdriver then grab one end and pull it and the staples off the door prying gently with a putty knife.
If your door is brand new then just try and make sure you can maintain it give it a clean give it a vacuum wipe it down with a clean cloth every now and again every couple of months. In addition to cleaning and lubricating sliding door tracks you want to lubricate the door lock. Lay down the door. How to repair sliding door rollers to work on patio door rollers lay the door down on a flat surface ideally a pair of sawhorses or a table.
Take a roller to your local hardware store and purchase a replacement. If it is still difficult to slide then you need to look at replacing the rollers. Each time you vacuum your floors use a small brush attachment or cordless vacuum to clean the sliding door tracks. Lift the door out.
Inspect the tracks top and bottom. The rollers are at the top and or at the bottom of the door. With the door removed you have an opportunity to do some other minor maintenance. To start your sliding glass door adjustment.
Remove the screws that hold the stop molding. Even basic maintenance might be the first port of call. Vacuum loose debris from the bottom track then clean with alcohol. Apply a lubricant to both upper and lower tracks to keep the door hardware clean and operating freely.
However you ll want to lubricate the bottom track by rubbing it a few times with a block of paraffin wax instead of silicon paraffin is more substantial and will hold up to the wear and tear the bottom track tends to take. Sink the broken ones with a hammer. It doesn t need a lot more. Remove any remaining staples with pliers.